Automationdirect.com HX-ECOM Series - Module Info> General Information; Module Info> Ethernet Stats; ECOM Settings

Ethernet Communications Modules, 3rd Edition, Rev. D
3–7
Chapter 3: Configuring ECOMs Using NetEdit3
1
2
3
4
5
6
7
8
9
10
11
12
13
14
A
B
C
D
Module Info> General Information
When the Module Info tab is selected, the General Info box lists the selected module’s
Firmware Revision, Booter Revision, DIP Switch Setting, PWB Revision, PLD Revision and
CPU Revision.
This box is in the lower left section of the NetEdit3 screen.
Module Info> Ethernet Stats
When the Module Info tab is selected, the Ethernet Stats box displays statistics related to the
selected module’s communication errors. Click on the Reset Stats button to reset all categories
to 0 (zero).
This box is in the lower middle section of the NetEdit3 screen.
ECOM Settings
When the ECOM Settings tab is selected, the selected module’s Configuration, Utilities and
Firmware tools can be accessed.
This box is in the lower middle section of the NetEdit3 screen