Automationdirect.com HX-ECOM Series - Modbus TCP Setup

Ethernet Communications Modules, 3rd Edition, Rev. D
5-24
Chapter 5: MODBUS TCP for H0/H2/H4-ECOM100
1
2
3
4
5
6
7
8
9
10
11
12
13
14
A
B
C
D
Modbus TCP Setup
To begin the Modbus TCP setup, highlight the desired ECOM100 module, and select the
“ECOM Settings” tab in lower frame of NetEdit3 window, then click the button marked
“Peer to Peer Config”.
You will get the popup screen seen below:
To add an entry, click the “Add” button, or “Edit” button to make changes to the existing
settings. Here we will choose “Add”. The Add Device Address popup will open.