Automationdirect.com HX-ECOM Series - Launching Netedit3; The Netedit3 Screen

Ethernet Communications Modules, 3rd Edition, Rev. D
3–3
Chapter 3: Configuring ECOMs Using NetEdit3
1
2
3
4
5
6
7
8
9
10
11
12
13
14
A
B
C
D
Launching NetEdit3
There are three methods to launch NetEdit3. The three methods are:
• using the Windows Start menu Programs>AutomationDirect Tools> NetEdit3
as shown below
• launching DirectSoft (if installed), from the programming window, select
PLC>Tools>NetEdit3
• launching DirectSoft (if installed), then select Utilities>NetEdit3
The NetEdit3 Screen
Starting NetEdit3 brings up the screen below. All NetEdit3 functions are accessed
from this screen.