Automationdirect.com HX-ECOM Series - H0; H2 Series ECOM DIP Switch

Ethernet Communications Modules, 3rd Edition, Rev. D
2–6
Chapter 2: Setup and Installation
1
2
3
4
5
6
7
8
9
10
11
12
13
14
A
B
C
D
H0 / H2 Series ECOM DIP Switch
If using the ECOM/ECOM100 module with Dataworx software, or the ECOM100 with
IBox Communication instructions, then dipswitch 7 must be set to ON.
The Module ID equals the sum of the binary values of the slide switches set in the ON position.
For example, if you set slide switches 1, 2, and 3 to the ON position, the Module ID will be
14. This is found by adding 8+4+2=14. The maximum value you can set on the DIP switch
is 32+16+8+4+2+1=63. This is achieved by setting switches 0 through 5 to the ON position.