Ethernet Communications Modules, 3rd Edition, Rev. D
B-4
Appendix B: General Specifications
1
2
3
4
5
6
7
8
9
10
11
12
13
14
A
B
C
D
Configuration
There are two ways to configure/edit the peerlink function in an ECOM100 (Do-more CPU
utilizing the built-in Ethernet port do not require any configuration):
• Start NetEdit3:
1. Right-click on your ECOM100
2. Select “Advanced...”
3. Check “Enable Web Server”
4. Press <OK> button
5. Right-click on your ECOM100 (again)
6. Select “Start Web based config....” --> This pulls up the configuration in your Internet
browser
7. Click on “Peerlink Settings”
• If ECOM100’s Web Server is already enabled: Start your Internet browser
1. In the address bar, enter your ECOM100’s IP address--> This pulls up the configuration.
2. Click on “Peerlink Settings”.
The Peerlink Settings screen looks like this:
To Next Page
Loading...