Automationdirect.com HX-ECOM Series - Page 44

Ethernet Communications Modules, 3rd Edition, Rev. D
3–11
Chapter 3: Configuring ECOMs Using NetEdit3
1
2
3
4
5
6
7
8
9
10
11
12
13
14
A
B
C
D
Clicking on the Find Hx-ECOM
button in the Add Device Address
window will display the Select
ECOM window shown to the right.
Highlight the server ECOM that you
intend to communicate with peer
to peer via the client ECOM(100)
module. Then click the OK button.
This will add the ECOM’s Device
Configuration information to
the previous Add Device Address
window.
Once the module’s network information is in the Add Device Address window (previous page),
click the OK button to add the information to the main Peer to Peer Configuration window.
Repeat the steps to add other ECOMs to the configuration. Clicking the OK button on the
main screen window writes the module(s) network information to the ECOM(100)’s flash
memory.