Autonics krn100 series Manual

KRN100
Series
A-16
Parameter Default Parameter Default Parameter Default Parameter Default
Select•UI•Card Auto•set Input•Type TC-K Low•Scale/High•Scale - Record•Method Instant
Input•Set•Copy CH•Select Range/Scale•Point 0.0 Special•Function None Filter•Type None
LCD/Paper•Record ON
Display/Temp••
Unit•
TC,•RTD
℃
Two•Unit - Filter•Counter -
Pen•Color Auto•set Analog % Reference•Channel - Burnout•Action OFF
Record•Zone None
High/Low•
Range••
&•Graph•Scale
Low -200.0 Input•Bias 0.0
Tag•Name CH-1•to•12 High 1350.0 Span -
Parameter Default Parameter Default Parameter Default Parameter Default
Record•Mode Graph Divide•Zone None Power•On•Status Hold Start•Line•Print ON
Digital•Print•type TwoCH Standard•Period - Run•Status OFF Range•Print•Time Disable
Standard•Speed 20mm/h Option•Period - List•Out•Option Standard
Option•Speed 20mm/h Listing•Language• English Zone•Dot•Line•Distance 4.0mm
Memo•Period 2hour Alarm•Speed 20mm/h CH•Print•Distance 20.0mm
Parameter Default Parameter Default Parameter Default Parameter Default
Device•Name KRN100•Recorder Summer•Time•Period - Alarm•Sound OFF Backlight•On/Off Temp
Date/Time Default•set Reservation•Type Disable Sampling•Rate 125ms
Date•Type yyyy/mm/dd Reservation•Period - Log•Speed 1s
Summer•Time Disable Reservation•Time - Backlight Standard
Parameter Default Parameter Default Parameter Default Parameter Default
Modbus•Address 1 Stop•Bit 2 RS485•Com•Write Enable Default•Gateway -
RS485•Port Enable Termination•Set Disable Ethernet•Port Disable Ethernet•Com•Write -
Baud•Rate 9600 Response•Wait•Time 20ms IP•Address - USB•Device•Port Enable
Parity•Bit None Protocol Modbus•RTU Subnet•Mask - USB•Com•Write Enable
Parameter Default Parameter Default Parameter Default Parameter Default
Select•UI•Card Auto•set Alarm •Ref•Channel -
Alarm •Hysteresis•
※
1
0.0
Alarm- •Status•
※
1
NO
Alarm•Set•Copy CH•Select
Alarm •Option•
※
1
None
Alarm •ON/OFF•Delay•
※
1
0s
Alarm1•Type•
※
1
PV.Hi
Alarm1•Value•
※
1
1350.0
Alarm •Alarm•No•
※
1
None
Alarm•2•to•4•Type•
※
1
None
Alarm•2•to•4•Value•
※
1
- Select•Alarm•Card Auto•set
Parameter Default Parameter Default Parameter Default Parameter Default
Load•Set•File None Memory•Status 0% USB•LogData•Save Disable
USB•Memory••
Copy/Move
USB•Copy/
Move..
Save•Set•File Select... Memory•Clear Clear... Memory•Save•Option Stop
Parameter Default Parameter Default Parameter Default Parameter Default
Select•DI•Card Auto•set DI- •Type None DI- •Reset•No - DI- •Status -
Input setting group [ INPUT SETUP ]
Record setting group [ RECORD SETUP ]
System setting group [ SYSTEM SETUP ]
Communication setting group [ COMMUNICATION SETUP ]
Alarm setting group [ ALARM SETUP ]
File/Memory setting group [ FILE/MEMORY SETUP ]
Digital input setting group [ DIGITAL INPUT SETUP ]
Factory default

Autonics krn100 series Specifications

General

Brand	Autonics
Model	krn100 series
Category	Measuring Instruments
Language	English