Need help?Do you have a question about the Autonics TX4S Series and is the answer not in the manual?
General| Storage Temperature | -20 to 60°C |
|---|---|
| Control Method | PID, On/Off |
| Input Type | Thermocouple, RTD |
| Power Supply | 100-240VAC 50/60Hz |
| Display | 4-digit LED |
| Output Type | Relay, SSR, Voltage, Current |
| Control Output | Relay, SSR drive output |
| Dimensions | 48 x 48 mm |
| Communication | RS485 (optional) |
| Operating Temperature | -10 to 50 ℃ |
| Alarm Output | 1 alarm output |
Defines high-limit deviation alarm operation and condition.
Defines low-limit deviation alarm operation and condition.
Defines high/low-limit deviation alarm operation and condition.
Defines high/low-limit reserve alarm operation and condition.
Defines high absolute value limit alarm operation and condition.
Defines low absolute value limit alarm operation and condition.
Detects sensor disconnection, triggers alarm output.
Detects loop break, triggers alarm output.
Corrects errors due to external input temperature sensors.
Stabilizes current temperature value against fluctuating input signals.
Controls load ON/OFF like standard relay output.
Controls load by repeating ON/OFF based on output rate within a cycle.
Controls load by phase within AC half cycle. Requires random turn-on SSR.
Pauses control output; hold keys for 3 sec to restart.
Forces clearing of alarm output.
Starts/stops auto-tuning process.
Details communication protocol, speed, and connection type.
Recommends specific communication converters for system setup.
Refers to user manual for communication settings and Modbus mapping.
Indicates where to find error information.
To Next Page