Parameter Factory default Parameter Factory default
IN-T KCA.H AHY5 1
UNIT C LBA.T 0
IN-B 0 LBA.T 2
MAvF 0.1 FS-L -50
L-SV -50 FS-H 1200
H-SV 1200 ADR5 1
O-FT HEAT BPS5 96
C-MD PID PRTY NONE
OUT CURR 5TP 2
SSR.M 5TND R5W.T 20
MA 4-20 COMW EnA
T
20.0 (Relay) DI-K STOP
2.0 (SSR drive) ErMV 0.0
AL-1 AM!A LOC OFF
AL-2 AM2.A ——- ——–
Parameter Groups
Order of parameter setup Parameter 2 group Parameter 1 group SV setting
All parameters are related one another. Set the parameters as above order.
If there is no key input for 30 sec while setting parameters, the new settings are ignored, and the unit will return to RUN mode
with previous settings.
When returning to RUN mode by holding the key for over 3 sec, press the key within 1 sec to re-enter the first parameter of
previous parameter group.
To Next Page
Loading...
