Resistance Test Result
How to use: When the probe clip (auxiliary ground lead) is
connected to an electrical circuit of resistance and the probe
tip is connected to the other end of the resistance, the probe
will automatically enter into the resistance display mode and
display the resistance values.
As shown in the figure: “BATT” means that the battery supply
voltage is 9.9V, and “OHM” is the current test resistance value
0.0 Ω.
7
●
Postive / Negative Test
When the probe detected voltage deviation of ±0.8v from the
power supply, the RED LED lights ON, meanwhile it displays
the voltage values, and the speaker sounds regularly. When
Probe detected the negative signal of the power supply, the
GREEN LED lights ON, and the speaker sounds regularly.
(Speaker Enable / Disable in Setting)
●
Functions Display
The bottom of the interface is the functional area from left to
●
●
Multimeter
mode
To Next Page
Loading...