CAUTIONS
Warning
Always perform automotive testing in a safe environment.
Do not attempt to operate or observe the tool while driving a
vehicle, operating or observing the tool will cause driver
distraction and could cause a fatal accident.
Wear safety eye protection that meets ANSI standards.
Keep clothing, hair, hands, tools, test equipment, etc. Away
from all moving or hot engine parts.
Operate the vehicle in a well-ventilated work area. Exhaust
gases are poisonous.
Put blocks in front of the drive wheels and never leave the
vehicle unattended while running tests.
Use extreme caution when working around the ignition coil,
distributor cap, ignition wires and spark plugs. These compo-
nents create hazardous voltages when the engine is running.
Put the transmission in P (for A/T) or N (M/T) and make sure
the parking brake is engaged.
Keep a fire extinguisher suitable for gasoline / chemical /
electrical fires nearby.
Don’t connect or disconnect any test equipment while the
ignition is ON or the engine is running.
Keep the scan tool dry, clean free from oil / water or grease.
Use a mild detergent on a clean cloth to clean the outside of
the scan tool when necessary.
Our company is not responsible for any damage caused by
unintentional or deliberate misuse of our products or tools.
Before using the instrument, please read this manual carefully
for proper operation.
1
To Next Page
Loading...
Need help?
General