10
Specifications
Hydrostatic Test Pressure ........................................................................................................... 300 psi (20.69 bar)
Working Pressure .......................................................................................................... 20-127 psi (1.38 - 8.76 bar)
Standard 12 Volt Transformer Input Electrical Rating ............................................................................115V 60 Hz
Optional 12 Volt Transformer Input Electrical Rating........................................................ 115V 50 Hz, 230V 50 Hz,
230V 60 Hz, 100V 60Hz, 100V 50 Hz
Transformer Cord .............................................................................................................................120 in (3.048 m)
Pressure Tank Thread ...................................................................................................................... 2 1/2 in -8 Male
Brine Line Thread .............................................................................................................................1/4 in NPT male
Distributor Tube Diameter Required .....................................................................................13/16 in OD (20.6 mm)
Distributor Tube Length............................................................. 1 1/4 in (31.8 mm) higher than top of mineral tank
Inlet-Outlet Manifold (Brass or NORYL) ............................................3/4 in NPT, 1 in NPT, 3/4 in BSPT, 1 in BSPT
Optional Bypass Valve, Control Module, Tank Adapter .............................................................Reinforced NORYL
Rubber Goods ................................................................................................. Compounded for cold water service
Brine Refill Control....................................... 1 to 10 lbs (0.45 to 4.5 kg) of salt or 3 to 19 lbs (1.3 to 8.6 kg) of salt
Injector Size “A” White ................................. Nozzle .042 in (1.1 mm) Diameter, Throat .089 in (2.3 mm) Diameter
Injector Size “B” Blue ................................... Nozzle .052 in (1.3 mm) Diameter, Throat .099 in (2.5 mm) Diameter
Injector Size “C” Red.................................... Nozzle .059 in (1.5 mm) Diameter, Throat .099 in (2.5 mm) Diameter
Backwash Controllers Available for..................................................................................... 7, 8, 9, 10, 12, 13, 14 in
(17.8, 20.3, 22.9, 25.4, 30.5 33.0, 35.6 cm) diameter mineral tanks.
All are sized to flow 4.5 gpm/sq ft (183 l/m/m2) of bed area.
Backwash Number 78910121314
Flow (GPM*) 1.2 1.6 2.0 2.5 3.5 4.1 4.8
Flow (LPM*) 4.5 6.0 7.6 9.5 13.2 15.5 18.2
*Approximate flow rates at 60 psi (4.14 bar)
11
Pressure Graphs
To Next Page
Loading...
