8
Removing the Series 255 Control
Module for Servicing
1. Unplug the transformer from the motor.
2. Shut-off water supply or put bypass valve(s) into
bypass position.
3. Remove cover (Figure 10-A), and with screwdriver,
relieve tank pressure by pushing open the valve on
control as shown (Figure 10-B).
4. Remove screw in locking bar (Figure 10-C).
Figure 10-A
Figure 10-C
Figures 10-B
13
Outlet
Drain
Inlet
Outlet
Drain
Inlet
Inlet
Drain
Outlet
To Next Page
Loading...
