ORBIT PRO
User Manual
The Orbit Pro’s receiver (RX) mode allows you to
receive audio from a Bluetooth enabled source (such
as a phone) and output it through a non-Bluetooth
compatible speaker or similar.
Use as Wireless Audio Receiver
(Receiver Mode)
STEP 1
Switch to the “RX” position.
TX
OFF
RX
STEP 2
Using the provided power cable, plug the Orbit Pro
into a wall outlet via 5V/500-mA-2A rated USB adapter
(any phone charger should work. Please contact
support@avantree.com if you'd like us to send you a
free adapter).
STEP 3
Connect to your speaker / soundbar via the included
AUX,RCA, or OPT cables. Plug the other end into the
Orbit Pro’s “OUTPUT” section.
20
EN
To Next Page
Loading...
