Figure 10: Wall mount mounting screw location
Installing a front mounted switch in an equipment rack
This procedure describes how to install a front mounted switch in a rack.
Before you begin
• Acquire a #2 Phillips screwdriver
Procedure
1. Attach a bracket to each side of the switch using a #2 Phillips screwdriver, as shown
in the following job aid. Attach the bracket with the round holes to the right side of
the switch where the round fan vents are located.
Procedures for installation of the switch
50 Installing Avaya Ethernet Routing Switch 5000 Series December 2013
Comments? infodev@avaya.com
To Next Page
Loading...
