Important:
The USB port on the back panel of the Ethernet Routing Switch 5600 Series models is not
enabled.
Placement options and cables
The following sections describe the available placement option and requirements, as well as
cables for the Ethernet Routing Switch 5000 Series switch.
Environmental requirements
This module describes the environmental requirements for the Ethernet Routing switches.
The Ethernet Routing switches must be properly mounted in a dry, well-ventilated area with
adequate power available for optimum operation. See the environmental specifications in the
job aid for Verifying environment suitability on page 43.
Placement options
You can mount 5000 Series switches on a flat surface such as a table or shelf, or in a rack.
Choose the mounting option that best suits your location. The following sections describe the
options.
Navigation
•
Switch installation on a table or shelf on page 16
• Switch installation on the wall on page 17
• Switch installation in an equipment rack, front mount option on page 17
• Switch installation in an equipment rack, rear mount option on page 17
Choose the mounting solution that suits your requirements and site.
Switch installation on a table or shelf
You can mount 5000 Series switch on a flat surface such as a table or shelf. See
Mounting on
a table or shelf on page 46, to install a single unit on a table or shelf.
The surface, whether a shelf or table, must be able to support the combined weight of the
switch and attached cables; between 21 and 33 pounds (9.5 to 15 kilograms) for a 5600 Series
switch.
Installation fundamentals
16 Installing Avaya Ethernet Routing Switch 5000 Series December 2013
Comments? infodev@avaya.com
To Next Page
Loading...
