Chapter 5: Procedures for installation of the
switch
Installation preparation
About this task
This procedure describes how to prepare to install a switch.
Warning:
To avoid bodily injury from hazardous electrical shock and current, never remove the top of
the device. There are no user-serviceable components inside.
Procedure
1. Determine the type of installation
2. Prepare the site.
3. Collect the tools required to install a switch.
Verifying environment suitability
About this task
This procedure describes how to verify environment suitability.
Procedure
To verify environmental suitability for installation of the Ethernet Routing Switch 5600
Series switch, ensure that the area where you want to install and operate the switch
meets the requirements listed in the following job aid.
Installing Avaya Ethernet Routing Switch 5000 Series December 2013 43
To Next Page
Loading...
