Avaya 5000 Series - IP Address Information Configuration

Job aid
The following graphic shows an SFP tranceiver.
Figure 16: SFP transceiver
IP address information configuration
About this task
The following sections contain information necessary to configure IP address parameters on
the switch.
Connecting a console
This procedure describes the steps to connect a console.
Before you begin
• Terminal with AC power cord and keyboard.
• Serial cable with a DB-9 female connector on both ends. The maximum length for the
console port cable is 25 feet (8.3 meters).
Procedure
1. Connect one end of serial cable to the DB-9 connector on the terminal.
2. Connect the other end of the serial cable to the DB-9 connector on the switch.
3. Turn the terminal on.
IP address information configuration
Installing Avaya Ethernet Routing Switch 5000 Series December 2013 63