Figure 15: Grounding lug location on a 5600 Series switch
Installing transceivers
About this task
This procedure describes the steps used to install transceivers.
Procedure
1. Remove the transceiver from the protective packaging.
2. Verify that the transceiver is the correct model for the network configuration.
3. Grasp the transceiver between the thumb and forefinger.
4. Insert the transceiver into the proper module on the switch. Apply a light pressure
to the transceiver until it clicks and locks into position in the module.
5. Remove the dust cover from the transceiver optical bores.
Procedures for installation of the switch
62 Installing Avaya Ethernet Routing Switch 5000 Series December 2013
Comments? infodev@avaya.com
To Next Page
Loading...
