Preparations for network connectivity
About this task
The following section contains procedures used to prepare 5000 Series switches for network
connectivity.
Cabling a standalone switch
This procedure describes the steps used to cable a standalone switch.
Procedure
1. Mount the switch. You can mount a standalone switch on a table or shelf, the wall,
or in a rack.
2. Connect the ground cable to the switch, see the following job aid for the location of
the ground lug.
3. Attach the required cables to the switch.
4. Install any required transceivers, see
Installing transceivers on page 62.
5. Connect the AC power cord.
Job aid
The following figure shows the location of the grounding lug on a 5600 Series switch.
Preparations for network connectivity
Installing Avaya Ethernet Routing Switch 5000 Series December 2013 61
To Next Page
Loading...
