Avaya 5000 Series - Hardware Installation Verification

Caution:
Ensure you use an appropriately rated AC power cord only. Do not use an
extension cord.
Connecting a DC power source to a 5600 Series switch
This procedure describes the steps necessary to connect a DC power source to a 5600 Series
switch.
Before you begin
• Ensure the DC power source is switched off.
Procedure
1. Plug the DC adapter into the power supply module.
2. Connect the DC leads to the adapter terminal block.
3. Tighten the screws on top of the adapter terminal block to secure the DC leads.
4. Attach the opposite ends of the leads to a –48V DC power source.
Hardware installation verification
Checking LEDs
About this task
This procedure describes how to check and interpret LEDs on the 5000 Series switches.
Procedure
To check and interpret front panel LEDs, compare the LEDs to the tables in the Job
aid section.
Hardware installation verification
Installing Avaya Ethernet Routing Switch 5000 Series December 2013 57