Avaya 5000 Series - Page 58

Job aid
The following tables describe the LED indicators.
Table 6: Switch LED state indicators
Label Color / Status Description
UI button White/steady Power is on.
Off Power is off.
Note:
The UI button is labeled Mode Select on Avaya branded equipment.
Pwr Green / steady The switch is connected to AC power and is receiving
power.
Green / blinking Problem with primary Boot image. Booted from back
up image. Configuration and agent code may be
incorrect.
Amber / slow blinking System will reset in less than 3 seconds. To stop the
reset, release UI push button.
Note:
The UI button is labeled Mode Select on Avaya
branded equipment.
Amber / fast blinking System will reset in less than 1 second. To stop the
reset, release UI push button.
Note:
The UI button is labeled Mode Select on Avaya
branded equipment.
Off The switch is not connected to an AC power source or
the power supply unit is not supplying power.
Status Green / steady
• During Initialization: The power-on self-test is
complete and the switch is operating normally.
• After Initialization: The front panel configuration
mode is inactive. Unit booted successfully.
Green / blinking
• During Initialization:: A non-fatal error occurred
during the self-test.
• After Initialization: The user pushed the UI button
and activated the front panel configuration mode
and the system is awaiting input.
Procedures for installation of the switch
58 Installing Avaya Ethernet Routing Switch 5000 Series December 2013
Comments? infodev@avaya.com