Label Color / Status Description
Amber / steady
• During Initialization: N/A
• After Initialization: The front panel has accepted the
user command. The system accepts the UI input and
is awaiting execution.
Amber / blinking
• During Initialization: N/A
• After Initialization: The system has rejected the UI
input.
Off The switch failed the self-test.
RPSU Green / steady The switch is connected to a redundant power supply
unit (RPSU) and is receiving power if necessary.
Green / blinking The switch is powered up with two or more supplies
and the AC has been removed. This is a non-service
affecting condition as the loss of one supply does not
stop system operation.
Amber / steady The switch is powered up with two or more supplies
and the PSU has been removed. This is a non-service
affecting condition as the loss of one supply does not
stop system operation.
Amber / blinking The switch is powered up with two or more supplies
and the DC output is off or bad. This is a non-service
affecting condition as the loss of one supply does not
stop system operation.
Off The switch is not connected to a RPSU, the RPSU is
not supplying power, or the DC/DC module is not
supplying power.
Up Green / steady The Cascade Up port has a physical connection to
another unit.
Amber / steady The Cascade Up port has detected an error.
Off The switch is in standalone mode or there is no link to
the Cascade Up port.
Down Green / steady The Cascade Down port has a physical connection to
another unit.
Amber / steady The Cascade Down port has detected an error.
Off The switch is in standalone mode or there is no link to
the Cascade Down port.
Base Green / steady The switch is the stack base unit.
Green / blinking There is a stack configuration error. Either multiple
base units or no base units are configured in the
stack.
Hardware installation verification
Installing Avaya Ethernet Routing Switch 5000 Series December 2013 59
To Next Page
Loading...
