Label Color / Status Description
Amber / steady The switch is operating as the temporary base unit in
the stack configuration.
Off The switch is not the stack base unit or it is operating
in standalone mode.
Table 7: Shared SFP transceiver Port LED state indicators
Label Color / Status Description
In Use Green / steady The port has a link established.
Off The port does not have a link established.
LNK/ACT Green / steady This link is operating normally.
Green / blinking There is activity on the port.
Green / slow blinking The port has been disabled by the software.
Off Indicates that the link has been lost.
Table 8: XFP transceiver port LED state indicators
LED Color / Status Description
Tx Green / steady
Rx Green / steady
Link established.
Tx Green / blinking Transmit activity detected.
Rx Green / blinking Receive activity detected.
Tx Amber / steady Transmit activity enabled.
Rx Amber / steady Fiber connected with signal present.
Tx Amber / blinking XFP has been installed. Laser Transmitter OFF or XFP in
Reset.
Rx Amber / blinking XFP has been installed. No Signal Detected or XFP in Reset.
Both Off No XFP installed.
The Amber LEDs are usually only used during the boot process. Under normal operation,
Green is the only color the XFP LED should emit.
Procedures for installation of the switch
60 Installing Avaya Ethernet Routing Switch 5000 Series December 2013
Comments? infodev@avaya.com
To Next Page
Loading...
