5. Secure the power supply module in the chassis by tightening the two retaining
screws. The following figure shows the captive screws.
Connecting an AC cord to switch
This procedure describes the steps used to connect an AC power cord to the switch.
Before you begin
To connect AC power to the switch an appropriate AC power cord is required.
About this task
Danger:
Use only power cords that have a grounding path. Without a proper ground, a person who
touches the switch is in danger of receiving an electrical shock. Lack of a grounding path to
the switch may result in excessive emissions.
Procedure
1. Connect the AC power cord to the back of the switch and then connect the cord to
an AC power outlet. The following figure shows the AC power cord connection to
the switch back panel.
Important:
The 5000 Series switches do not have an AC power switch. When the power cord
is connected to a suitable AC power outlet, the switch powers up immediately.
Warning:
Disconnecting the AC power cord is the only way to turn off AC power to the 5000
Series switches. Always connect the AC power cord in a location that can be
reached quickly and safely in case of an emergency. For a translation of this
statement, see
Translations of safety messages on page 81.
2. Insert the male end of the power cord in a standard 110/220 V AC power outlet.
Procedures for installation of the switch
56 Installing Avaya Ethernet Routing Switch 5000 Series December 2013
Comments? infodev@avaya.com
To Next Page
Loading...
