Figure 12: Rack mount
Installing a rear mounted switch in an equipment rack
The Ethernet Routing Switch 5600 Series switch provides the option for installing the switch
in a rear mounted configuration. This option allows the switch to be installed with the back
panel facing forward.
Before you begin
• Acquire a #2 Phillips screwdriver
About this task
This procedure describes how to install a rear-mounted switch.
Procedure
1. Attach a bracket to each side of the switch using a #2 Phillips screwdriver, as shown
in
Figure 13: Attaching rear mounted switch brackets on page 53. Attach the
Procedures for installation of the switch
52 Installing Avaya Ethernet Routing Switch 5000 Series December 2013
Comments? infodev@avaya.com
To Next Page
Loading...
