Assigning IP parameters using Enterprise Device Manager
About this task
The following procedure describes how to use Quick Start to assign IP parameters to the
Ethernet Routing Switch 5000 Series.
Procedure
1. Connect a computer to the switch through a data port using a standard RJ-45
network cable.
2. Open a Web browser on the attached computer.
3. Enter the factory default IP address of the switch in the following format: http://
<IPAddress>.
The main screen of the Enterprise Device Manager Interface opens.
4. In the navigation pane, click Administration > Quick Start.
The IP/Community/Vlan work area opens.
5. In the In-Band Stack IP Address dialog box, type a switch or stack IP address .
6. In the In-Band Subnet Mask dialog box, type a subnet mask.
7. In the Default Gateway dialog box, type an IP address.
8. Click Apply.
Note:
For more information about switch configuration, see Getting Started with Avaya
Ethernet Routing Switch 5000 Series, NN47200–303.
Verifying assigned IP address is reachable
This procedure describes a method of verifying that the assigned IP address is reachable.
Before you begin
• Ensure you have assigned an IP address to the switch.
• Physically connect the switch to the network.
• Ensure the terminal from which you ping the switch is on the same network as the
switch.
Procedures for installation of the switch
66 Installing Avaya Ethernet Routing Switch 5000 Series December 2013
Comments? infodev@avaya.com
To Next Page
Loading...
