Pre-Installation Checklist
Issue 1 August 2011 11
2. There are available ports on a DCP module in the Avaya Aura Communication
Manager system. The following DCP modules are supported on the switch:
● TN2214
● TN2224
● MM312
● MM712
● MM717
!
Important:
Important: For more information about DCP modules, see the Communication
Manager Software and Firmware Compatibility Matrix on the Avaya
support web site http://www.avaya.com/support
.
Note:
Note: If your system has MM312, MM712, or MM717 DCP boards, you
must update the firmware for these boards to V14 before upgrading
the firmware for the 9400 Series Digital Deskphones.
3. The available ports are wired to the cross-connect field or termination closet.
4. The Avaya Aura Communication Manager system is configured correctly. The
Avaya Aura Communication Manager documentation is available at
http://www.avaya.com/support
.
Requirements to Verify for Each 9400 Series Deskphone
5. You have an extension number on the Avaya Aura Communication Manager
system.
6. You know the room location, jack number, and wire number.
7. You know the port address.The port address is a combination of the port network,
carrier, board slot, and port number (for example, 01a0515 - port network 1, carrier
A, 5th slot, 15th port) or the gateway number, module slot, and port number (for
example, 031v405 - media gateway 31, virtual slot 4, and port 5 on the MM712
card). You can determine the port address using the list configuration station
command from the Avaya Aura Communication Manager administration interface.
Note:
Note: You can also use the TTI feature access code to install a 9400
Series Deskphone.
8. A digital jack is available at each telephone site.
Verify These Avaya Aura Communication Manager Requirements (continued)
To Next Page
Loading...
