Avaya BCM50 - Page 51

BCM50 System Start Up
NN40010-318 Issue 1.2 BCM50 Rls 6.0 51
DPNSS Module-Specific Settings
Attribute
Value
Description
Clock Source
Primary
Secondary
Timing Master
Designates whether the DTM/BRI acts as a
primary or secondary timing component for an
external timing source or as the internal timing
source. Note: A BRI module can be
programmed with primary/secondary clock
source, however, it is recommended that a
BRI module always be set to Internal if a DTM
exists on the system to be the Primary
External clock source.
Host node
M1
Embark
IDPX
DSM
DPNSS cards connected to Embark switches
have a different way of handling call diversion,
therefore, when you provision a DTM for
DPNSS, you must indicate what type of switch
the lines are connected to.
When you select the Embark switch, calls are
diverted using the Call Forwarding feature
instead of call diversion.
DPNSS Local
Number Length
1-10
This number allows the system to determine
how many digits to read on an incoming call to
determine that the call is meant for this
system.