BCM50 System Start Up
24 NN40010-318 Issue 1.2 BCM50 Rls 6.0
Configuring the LAN IP Address
If the IP Address of the BCM system requires changing, i.e. to suit the
customer’s network, use the following procedure.
Note: If configuring a BCM50(b)e, you must ensure that the Router LAN IP
Address and the BCM LAN IP address are on the same subnet. Refer to the
BCM50 Router LAN Settings guide for more information.
All LAN ports will use this IP Address, unless VLANs are to be configured
(refer to the VLANs Guide for more information). The LAN IP Address does
not apply to the OAM port.
1. Access Element Manager (refer to Element Manager Connection to
the BCM section of this guide).
2. In the Configuration tab open the System heading and click on IP
Subsystem.
To Next Page
Loading...
