DEFINITY Enterprise Communication Server Release 9
Installation and Maintenance for Survivable Remote EPN
555-233-121
Issue 2
November 2000
SREPN Installation
1-17Power up the SRP
1
Power up the SRP
1. Set the TN2301 switch to the Restore (RSTR) position during the
administration to prevent the cabinet from going into the survive mode.
2. At the rear of the SRP, set the circuit breaker to ON. This starts the system
initialization and test.
Administer the Release 9r and SRP
!
CAUTION:
Do not save announcements to the SRP translation card.
NOTE:
Administering the SRP may take several hours.
NOTE:
This documentation assumes that the Release 9r system access
terminal and the SRP system access terminal are located in the
same room. If this is not the case, make the appropriate provisions.
NOTE:
An init login is required to perform the following. Contact the regional
CSA (Customer Software Associate) to assign the Offer Category
option. Maintenance capabilities to initialize the system and access to
either an internal or external modem are the only command options
available until the Offer Category option is set.
NOTE:
Not all administration should be copied directly (Example: coverage
paths, abbreviated dial lists, and bridged appearances). These
administration items may not be valid if the SRP goes into survival
mode.
NOTE:
The following are examples of the types of administration that need to
be added to the SRP. Since configurations and administration varies
for every switch, it is not possible to list all of the administration that is
needed for your SRP.
To Next Page
Loading...
