Feature operation
Issue 4 July 2001 35
To use Loudspeaker Paging with paging buttons:
1. Press an idle paging zone button. If the desired paging zone is already in
use (the associated lamp is on), select another zone or wait for that zone to
become idle (the associated lamp is off).
■ The lamp for the selected paging zone goes on.
■ If the PAGE ALL button is selected, all paging zone lamps go on.
2. Speak into the handset to make the announcement.
■ The announcement was heard in the selected zone(s). If the
announcement lasted too long, you will hear intercept tone; release
the button and try again.
3. Press the
RELEASE button.
To use Loudspeaker Paging with trunk access codes:
1. Press the
START button or an idle call appearance button.
■ You hear a dial tone.
■ The call appearance lamp goes on.
■ The Position Available lamp goes off.
2. Dial the trunk access code for the zone you wish to page.
■ If you hear confirmation tone, continue with Step 3.
■ If you hear busy tone, the zone is not available; press the CANCEL
button and try again later.
3. Speak into the handset to make the announcement.
■ The announcement was heard in the selected zone(s). If the
announcement lasted too long, you will hear intercept tone; try again
with a shorter announcement.
4. Press the
RELEASE button.
To Next Page
Loading...
Need help?
General
