Switch Administration
2-8 Issue 6 September 2001
to re-assign and/or reuse the downloadable Cluster ID associated with a
radio controller circuit pack. The Cluster ID, also known as a Cell ID, is
used by the switch to page a WT in a specific cell. The Cluster ID for an
administered radio controller circuit pack is displayed on the list
configuration radio controller command.
The RC# field is a system assigned ID that cannot be changed.
The Location field contains the circuit pack address PPCSS of an
administered radio controller circuit pack. The field is populated and
maintained by the system. It cannot be changed by the user.
The ID field contains the Cluster ID for an RC.
a. On a new system, where there are no radio controllers
administered, the default value for all Location and ID fields is blank.
b. When a radio controller circuit pack is added to the system using the
add radio command, the ID field for that RC contains a system
assigned ID from 1-32. This number can be verified using the list
configuration radio-controller all command.
c. To re-assign or reuse a Cluster ID, change the ID field for an RC.
Valid values are 1-32.
Figure 2-5. Radio Controller Cluster ID Assignments
RADIO CONTROLLER CLUSTER ID ASSIGNMENTS
Page 2 of 4change system-parameters wireless
RC# Location ID
RC# Location ID RC# Location ID
RC# Location ID
1: 02C08
2: 02C09
3:
10:
17:
18:
19:
20:
21:
22:
23:
24:
25:
26:
27:
28:
29:
30:
31:
32:
4:
5:
6:
7:
8:
9:
11:
12:
13:
14:
15:
16:
33:
34: 02C14
35:
36:
37:
38:
39:
40:
41:
42:
43:
44:
45:
46:
47:
48:
2
9
9
49:
50:
51:
52:
53:
54:
55:
56:
57:
58:
59:
60:
61:
62:
63:
64:
To Next Page
Loading...
Need help?
General
