Procedure: Software Installation
Issue 6 September 2001
2-9
NOTE:
Once an ID has been changed, busyout, reset and release must be
done for each RC board whose ID has changed in order for it to get
downloaded to the RC board.
16. Submit the completed form.
17. Execute the change carrier-frequencies command to administer the
carrier frequencies.
NOTE:
All frequencies that are administered as y on the System-Parameters
Wireless form are also defaulted to y on the Carrier-Frequencies
form. This form must be changed only if the customer is not going to
use a frequency that has been approved for use by the FCC.
If this field is changed, you must busy out, reset, and release all
administered RCs before the change will be read into the RCs.
Figure 2-6. Wireless Carrier Frequencies Form
NOTE:
This form enables the user to limit the radio transmission to a subset
of those carrier frequencies allowable for the DWBS. The form allows
the user to limit radio transmissions without infringing upon any
UTAM restrictions.
WIRELESS CARRIER FREQUENCIES
Page 1 of 1
change carrier-frequencies
Customer Carrier Frequencies (MHz)
0: 1929.375
y
1: 1928.125
y
2: 1926.875
y
3: 1925.625 y
4: 1924.375
y
5: 1923.125
y
6: 1921.875
y
7: 1920.625 y
To Next Page
Loading...
Need help?
General
