EasyManuals Logo

Avaya ESS User Manual

Avaya ESS
192 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #159 background imageLoading...
Page #159 background image
Enterprise Survivable Servers - Maintenance Commands
Issue 1.1 June 2005 159
Com Num The community number of the Port Network (1 - 64) assigned to the Port
Network on display system-paramters. Port networks have a
natural attraction for local preferred media servers in the same community.
In the event of loss of connectivity with their server, they prefer to be
controlled by a server in their community if possible.
Intf Loc Interface Location. Board location of the most recent interface in the Port
Network with which the system tried to control the Port Network.
The interface may be any circuit pack through which the Port Network may
be controlled, such as a TN2312 IP Server Interface (IPSI), a TN2305B or
TN2306B ATM Expansion Interface (ATM EI), or a TN570D Expansion
Interface (CSS EI):
blank = there is no interface
Intf Type The type of interface whose location is shown in the Intf Loc field:
IPSI = IP Server Interface
EI = either type of Expansion Interface (TN570 or TN2305/2306)
UNKN = the interface type cannot be determined
blank = there is no interface
Port Ntwk Ste The Port Network state from the point of view of the server on which
status ess port-networks is run:
up = the Port Network is up
down = the Port Network is down
unkn = the state is unknown
blank = there is no Port Network state
The Port Network is up from the perspective of the media server that is
controlling the Port Network.
The Port Network is down from the perspective of all other media servers.
IPSI Gtway Loc IPSI Gateway Location. The location of the IPSI whose Packet Interface
(PKTINT) is being used to deliver packet traffic to the packet bus in this Port
Network. The IPSI may be in this Port Network (this location is the same as
Intf Loc), or it may be in a different Port Network.
Pri / Sec Loc The location of the Primary and Secondary IP Server Interface (if any) in
this Port Network.
If the Port Network has a single IPSI, only one line is displayed.
If the Port Network has duplicated IPSIs equipped, each is displayed
on successive lines.
blank = the Port Network has only an Expansion Interface from which
it is controlled
status ess port-networks field descriptions (continued)
Field Description
2 of 4

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Avaya ESS and is the answer not in the manual?

Avaya ESS Specifications

General IconGeneral
BrandAvaya
ModelESS
CategoryServer
LanguageEnglish

Related product manuals