Avaya ESS

Enable an ESS server from the Main server
Issue 1.1 June 2005 185
Enable an ESS server from the Main server
What to expect
Communication Manager on the selected ESS server resets. Once the ESS server resets it will
re-register with the Main server. Once registered, the ESS server receives a translation
download from the Main server and resets. After the reset, the ESS server re-registers with the
Main server.
What this test is used for
Use this test to verify the ability to enable an ESS server from the Main server
1. On the Main server, execute the enable ess cluster <cluster ID> command.
Acceptance criteria
Verify that the selected ESS server is now enabled:
1. On the Main server:
a. After the ESS server comes back up from the reset and re-registers with the Main server,
execute the status ess clusters command from the Main server SAT. Verify that:
- The enabled state under the Enabled? column, shows y.
2. On the ESS server:
a. Execute the status ess clusters command. Verify that:
- The enabled state under the Enabled? column, shows y.