Avaya J100 Series - Page 207

Parameter name Default
value
Description
Value Operation:
• 0: Continue using the address in
an extended rebinding state.
• 1: Immediately stop using the
address.
DIALPLAN Null Specifies the dial plan used in the
phone.
Dialplan accelerates dialing by
eliminating the need to wait for the
INTER_DIGIT_TIMEOUT timer to
expire.
The value can contain 0 to 1023
characters. The default value is
null.
DISCOVER_AVAYA_ENVIRONMENT Specifies dynamic feature set
discovery
Value Operation:
• 1: The phone discovers and
verifies if the controller supports
the AST feature set or not. The
phone sends a SUBSCRIBE
request to the active controller for
the Feature Status Event
Package (avaya-cm-feature-
status). If the request succeeds,
the phone proceeds with PPM
Synchronization. If the request is
rejected, or is proxied back to the
phone, or does not receive a
response, the phone assumes
that AST features are not
available.
• 0: The phone operates in a mode
where AST features are not
available.
Note:
Set the parameter to 0 for IP
Office environment.
DISPLAY_SSL_VERSION 0 Specifies whether OpenSSL and
OpenSSH versions are displayed in
the Administration menu.
Table continues…
List of configuration parameters
December 2018 Installing and Administering Avaya J100 Series IP Phones 207
Comments on this document? infodev@avaya.com