Avaya J100 Series - Page 239

Parameter name Default
value
Description
certificate request is pending for
manual approval.
Value Operation:
• 0: Poll the SCEP server
periodically in the background.
• 1: Wait until a certificate is
received or the request is
rejected.
N
NO_DIGITS_TIMEOUT 20 Specifies the number of seconds
the phone waits for a digit to be
dialed after going off-hook and
before generating a warning tone.
Valid values are 1 through 60.
O
OCSP_ACCEPT_UNK 1 Specifies whether in cases where
certificate revocation status for a
specific certificate cannot be
determined to bypass certificate
revocation operation for this
certificate.
Value operation:
• 0: Certificate is considered to be
revoked if the certificate
revocation status is unknown.
TLS connection will be closed.
• 1: Certificate revocation operation
will accept certificates for which
the certificate revocation status is
unknown.
OCSP_CACHE_EXPIRY 2880 Specifies the time interval for the
OCSP cache expiry in minutes.
OCSP response cache expiry uses
nextUpdate value in OCSP
response message. If nextUpdate
is not present, then
OCSP_CACHE_EXPIRY
parameter value is used.
Valid range is from 60 to 10080
Table continues…
List of configuration parameters
December 2018 Installing and Administering Avaya J100 Series IP Phones 239
Comments on this document? infodev@avaya.com