Avaya J129 - Page 226

Parameter name Default
value
Description
HANDSET_PROFILE_NAMES Null Specifies an ordered list of names
to be displayed for handset audio
profile selection. The list can
contain 0 to 255 UTF-8 characters.
Names are separated by commas
without any intervening spaces.
Two commas in succession indicate
a null name, which means that the
default name should be displayed
for the corresponding profile.
Names might contain spaces, but if
any do, the entire list must be
quoted. There is no way to prevent
a profile from being displayed.
HEADSET_PROFILE_DEFAULT 1 Specifies the number of the default
headset audio profile.
Valid values are 1 through 20.
HEADSET_PROFILE_NAMES Null Specifies an ordered list of names
to be displayed for headset audio
profile selection.
The list can contain 0 to 255 UTF-8
characters.
Names are separated by commas
without any intervening spaces.
Two commas in succession indicate
a null name, which means that the
default name is displayed for the
corresponding profile. Names can
contain spaces, but if any do, the
entire list must be quoted. There is
no way to prevent a profile from
being displayed.
HEADSYS 0 Specifies whether the phone goes
on-hook if the headset is active
when the disconnect message is
received.
Value Operation:
• 0: The phone goes on-hook if the
disconnect message is received
when the headset is active.
• 1: Disconnect messages are
ignored when the headset is
Table continues…
Appendix
December 2018 Installing and Administering Avaya J100 Series IP Phones 226
Comments on this document? infodev@avaya.com