Avaya J159 - Page 5

© 2020 Avaya Inc. All Rights Reserved.
To connect the Avaya J159 IP Phone to the Avaya Cloud O󽗋ce, you must 󽗉rst connect
the device to the network and power it up.
1. If your router has PoE port available, connect the J159 ethernet port to your router.
The power adapter is not required in this case. The device bootup will start.
PoE
ROUTER - SWITCH
ROUTER - SWITCH
123
456
7
89
*
0#
123
456
7
89
*
0#
2. If your router does not have PoE port available, connect the J159 ethernet port
to the available port on your router. Connect the power adapter to the J159.
The device bootup will start.
PoE
ROUTER - SWITCH
ROUTER - SWITCH
123
456
7
89
*
0#
123
456
7
89
*
0#
3. Once the device is boots up, it will obtain an IP address from your network.
4. Once connected to the network, the device will automatically connect to ACO,
and login.
5. The device may reboot if there is new software that needs to be installed.
The latest software for ACO must always be installed on the device in order for
it to connect to ACO and provide service.
6. Once the device has network connectivity, allow any upgrades to be completed
successfully before attempting to use the phone.
If you are connecting the Avaya J159 IP Phone to the network, via the optionally
provided WiFi module:
1. Install the WiFi module in the module panel using the instructions provided with
the WiFi module.
2. Connect the power adapter to the J159.
3. Continue from Step 3 above.
Instructions