Avaya J179 - Page 218

Parameter name Default
value
Description
Value operation:
• 0: Embedded public CA
certificates are only trusted when
TRUSTCERTS is empty.
• 1: Embedded public CA
certificates are always trusted.
ENABLE_RECORDING 0 Specifies if audio debug recording
is enabled for users.
Value Operation:
• 0: Audio debug recording is
disabled.
• 1: Audio debug recording is
enabled.
ENABLE_REDIAL Specifies if Redial softkey is
available.
Value Operation:
• 0: No
• 1: Yes
ENABLE_REDIAL_LIST Specifies if the phone redials last
number or displays list of recently
dialed numbers.
Value Operation:
• 0: Last number redial
• 1: User can select between the
last redialled number and the
redial list.
•
Note:
Avaya J139 IP Phone does not
support this feature.
ENABLE_REMOVE_PSTN_ACCESS_PREFIX Allows phone to perform digit
manipulation during failure
scenarios. This parameter allows
removal of PSTN access prefix
from the outgoing number.
Table continues…
Appendix
December 2018 Installing and Administering Avaya J100 Series IP Phones 218
Comments on this document? infodev@avaya.com