Avaya J179 - Page 219

Parameter name Default
value
Description
Value Operation;
• 0: PSTN access prefix is retained
in the outgoing number.
• 1: PSTN access prefix is removed
from the outgoing number.
ENABLE_SHOW_EMERG_SK 2 Specifies whether an Emergency
softkey, with or without a
confirmation screen, is displayed
when the phone is registered. All
emergency numbers are always
supported.
Value Operation:
• 0: Emergency softkey is not
displayed.
• 1: Emergency softkey is
displayed without a confirmation
screen.
• 2: Emergency softkey is
displayed with a confirmation
screen.
Note:
The parameter is set to 0 for
IP Office environment.
ENABLE_SHOW_EMERG_SK_UNREG 2 Specifies whether an Emergency
softkey, with or without a
confirmation screen, is displayed
when the phone is not registered.
All emergency numbers will always
be supported.
Value Operation:
• 0: Emergency softkey is not
displayed.
• 1: Emergency softkey is
displayed without a confirmation
screen.
• 2: Emergency softkey is
displayed with a confirmation
screen.
Table continues…
List of configuration parameters
December 2018 Installing and Administering Avaya J100 Series IP Phones 219
Comments on this document? infodev@avaya.com