Avaya one-X - Page 30

Local Administrative Options
30 9600 Series SIP IP Telephones Release 1.0 Installation and Maintenance Guide
Use the following procedure to invoke manual address information programming.
1. When you select ADDR... from the Admin Procedures Screen, the Static Addressing Local
Procedure screen displays as follows with the prompt “Select address to change.”:
where:
● nnn.nnn.nnn.nnn is the current IP Address associated with the specific address
information to its left, which could be either a value previously set by a technician, or the
original IP Address value if no previous change was made,
● L2Q text string is the text string associated with the current system value of the
L2QVLAN parameter.
● dddd is the current value of L2QVLAN and ddd is the current value of VLANTEST,
respectively.
2. Use the navigation arrows to scroll to and highlight the address you want to change, then
use the appropriate softkey(s) and the dialpad to change the value as described in Step 3.
3. Depending on the item you selected, choose one of the following:
Static Addressing screen Line Description and (System
Value)
Use DHCP
Phone
Router
Subnet Mask
HTTPS File Server
HTTP File Server
DNS Server
VLAN ID
VLANTEST
VLAN Tagging
Yes
nnn.nnn.nnn.nnn
nnn.nnn.nnn.nnn
nnn.nnn.nnn.nnn
nnn.nnn.nnn.nnn
nnn.nnn.nnn.nnn
nnn.nnn.nnn.nnn
dddd
ddd
0
Yes or No
Telephone IP Address (IPADD)
Router in use; gateway/router IP
Address(es)
IP network mask (NETMASK)
IP Address of HTTPS File Server
IP Address of the HTTP File Server
DNS server IP Address(es)
L2QVLAN value
Number of seconds to wait for a
DHCP offer
L2Q value (0=auto, 1=on, 2=off)
If you want to Then
Change any of the IP
Address values (File,
Phone, Router, Subnet
Mask, &/or DNS Server)
Use the dialpad to enter the new IP Address. IP Addresses have
three sets of three digits followed by a period. Pressing *
following entry of three digits causes a period to be placed in the
next position, and the cursor to advance one position to the right.
For example, to enter the IP Address 111.222.333.444, press the
1 on the dialpad three times then press *, press the 2 on the
dialpad three times then press *, press the 3 on the dialpad three
times then press *, then press the 4 on the dialpad three times.
Proceed to the next step.
Change the VLAN ID value Use the dialpad to enter the new static VLAN ID of from 0 to
4094, inclusive. Proceed to the next step.
Change the VLANTEST
value
Use the dialpad to enter the new value of the DHCPOFFER wait
period of from 0 to 999, inclusive. Proceed to the next step.