Configuring Time Server Settings
Issue 1 May 2007 39
Configuring Time Server Settings
Use this procedure to designate a server for Simple Network Time Protocol (SNTP) and to set
corresponding values.
1. When you select SNTP... from the Admin Procedures Screen, the telephone displays the
following settings and prompts you to enter the IP Address of the SNTP server:
2. To change a setting:
- If the field shows Right/Left Arrow indicators, press the Right (or Left) navigation arrow
to cycle through the available settings.
- If the field does not show Arrow indicators, press the appropriate softkey(s) and use the
dialpad to enter the new value.
3. Press Save to store the new setting and redisplay the Admin Procedures screen.
The View Administrative Option
If you are using static addressing and encounter problems, use the following procedure to verify
the current values of system parameters and file versions.
Note:
Note: Unless otherwise prevented using administration, the user can view but not
change most of the parameters associated with Craft Local Procedures. For
more information about this option, see the applicable user guide(s).
Note:
Note: If the View Network Information option is not available due to being disabled by
administration, use the ADDR option to view IP Addresses. See Static
Addressing Installation on page 29. The IP Addresses might have been entered
incorrectly. Verify whether you were provided with correct IP Addresses.
Description/Example
SNTP Server:
SNTP GMT Offset:
SNTP Daylight Savings Time:
IP address of the network time server.
Local time difference in hours from Greenwich
Mean Time, e.g., NJ is -5.
Indicates whether the telephone should
recognize Daylight Savings Time (DST)(0=no
DST, 1=DST activated as per DSTOFFSET,
2=.automatic based on DSTSTART and
DSTSTOP values.
To Next Page
Loading...
