Local Administrative Options
38 9600 Series SIP IP Telephones Release 1.0 Installation and Maintenance Guide
Use the following procedure to set the Site-Specific Option Number (SSON).
1. When you select SSON... from the Admin Procedures Screen, the following text displays:
where the setting is the current system value of DHCP_SSON.
2. To change the setting, press the appropriate softkey(s) and use the dialpad to enter a valid
SSON value between 128 and 255.
3. Press Save to store the new setting and redisplay the Admin Procedures screen.
Configuring SIP Settings
Use this procedure to set up SIP-related settings like identifying the SIP Proxy Server.
1. When you select SIP... from the Admin Procedures Screen, the telephone prompts you to
use the Right and Left navigation arrows to change a setting and displays the following
settings and their active values:
2. To change a setting:
- If the field shows Right/Left Arrow indicators, press the Right (or Left) navigation arrow
to cycle through the settings. Depending on the current value, the next sequential value
displays.
- If the field does not show Arrow indicators, press the appropriate softkey(s) and use the
dialpad to enter the new value.
3. Press Save to store the new setting and redisplay the Admin Procedures screen.
Setting:
Setting Description/Example
SIP Mode:
SIP Domain:
Avaya Environment:
Transport Type:
SIP Proxy Server:
Avaya Config Server:
User ID Field:
Proxied or Peer-to-Peer.
e.g., avaya.com
Yes or No - indicates whether only an Avaya
environment (CM & SES) is in effect.
TCP or TLS or UDP.
IP Address
IP Address of Avaya configuration server - only if
PPM (Personal Profile Management) is not located
at the same server as the SIP Proxy server.
Ignore; not currently used.
To Next Page
Loading...
