Install the software
03-300528 Issue 6 May 2009 27
Install the software
Note: The software CD-ROM that the customer received with the original server
contains the Linux operating system and the appropriate release of Avaya
Communication Manager. In most cases, the software that you install after the
server replacement procedure is the same release and version of the software
that was previously installed and running on the original server.
To install the Communication Manager software and optionally, Communication Manager
Messaging on the server:
1. Assign the IP address 192.11.13.5 and subnet mask 255.255.255.252 to your laptop.
2. Connect the laptop to the services port (eth1) using a crossover cable.
3. Connect the DVD/CD-ROM drive to a USB port.
4. Insert the software CD in the tray to install Communication Manager.
5. At your laptop click on Start > Run to open the Run dialog box.
6. Type telnet 192.11.13.6 and press Enter.
If the DVD/CD drive was not attached to a USB port when the server booted up, you will not
see any activity on the screen. In this case perform the following:
a. Press the Shut Down button on the server.
b. When the OK-to-remove light comes on, connect the DVD/CD-ROM drive to a USB port.
c. Unseat and reseat the S8300C or S8300D in its slot.
Tip: To navigate the installation screens, use the arrow keys to move to an option,
then press the space bar to select the option. Press Enter to submit the screen.
7. Select Install and press Enter.
The system displays the Select Release Version screen.
8. Select the appropriate release version then select OK and press Enter.
The system displays the Select Messaging Options screen.
Note: Communication Manager Messaging is optionally installed on the server when
you install Communication Manager. If the customer was not using
Communication Manager Messaging before the equipment replacement, do not
install it.
9. Select from one of the following:
● CM Only <No Messaging>
To Next Page
Loading...
