03-300528 Issue 6 May 2009 65
Job Aid: Supported CD/DVD-ROM drives
This Job Aid describes the supported CD/DVD-ROM drives that technicians must use to install
software on the Avaya S8300-Series Servers.
Important: Always check the Avaya Support Website for Product Correction Notices at
http://support.avaya.com
and select Product Correction Notices (All Avaya
products) in the MOST POPULAR PRODUCTS IN SUPPORT section.
This Job Aid contains these topics:
● Panasonic Digistor
● TEAC
● Addonics
● Connecting to the server
Panasonic Digistor
You can purchase Avaya approved Panasonic Digistor models - 73082 or 73322 (Comcode:
700406267)
● The switch must be turned to the ON position.
● Instead of AC power, the Panasonic uses Lithium ION battery for additional power. USB
2.0 readers draw more power than the standard USB ports that are available on the
S8400/S8300 Servers can supply. To compensate for this shortfall, the Digistor drive
contains an internal Lithium ION battery that makes up the current difference between
what the USB port can provide and what the CD/DVD-ROM drive requires.
The internal Lithium ION battery must be fully charged for the drive to operate properly.
Anytime the Lithium ION battery is depleted and the drive attempts to operate, the red LED
on the top of the case will light and a "failed to mount cdrom" message appears on the
laptop screen. The red LED is not bright so careful observation is required. The Lithium ION
battery can be charged by plugging the CD-ROM drive in a USB port for approximately 30
minutes. The Lithium ION battery charges faster if the ON/OFF switch is set to OFF. To
preserve the battery, keep the ON/OFF switch in the OFF position until you are ready to use
the Digistor drive.
To Next Page
Loading...
