Appendix 1: Set up a TFTP Server
03-300528 Issue 6 May 2009 53
8. Go to the directory where the TFTP software was installed and double-click on the program
tftpserver32.exe.
The TFTP Server window appears. The IP address of the computer, plus port 69, is
indicated in the upper border of the window.
9. Enable the TFTP server as follows:
a. Click on System from the menu bar and select setup.
The server option window appears.
b. Select the Outbound tab, and enter the full path to the tftp directory that you created
earlier (e.g., C:\tftpboot) in the Outbound file path window.
c. Select the Inbound tab, and enter the full path to the tftp directory that you created
earlier (e.g., C:\tftpboot) in the Inbound file path window.
d. Under Options tab, enter 69 in the Use Port field (default).
e. Select No Incoming (default). However, if you wish to copy files as a backup prior to
performing an upgrade of software, leave this field unchecked.
f. Click OK.
Note: When you want to use the TFTP server, double-click on the program
tftpserver32.exe, and in the File menu, select Start Serving. You can toggle the
program off by selecting Stop Serving.
To Next Page
Loading...
