© 2017 Avaya Inc. All rights reserved
Release Notes for Avaya Scopia® XT Series Known Issues | 42
the endpoint is listed with
forbidden icon or manual
pairing will fail with "Endpoint
unavailable" message).
precedence for presentation.
Presentation priority with “Presentation Content on
HD1” enabled is HD1/DVI/Screen Link. You need to
unplug both HD1 and DVI to have XT show Screen
Link content.
Please note that if you plug in DVI or HD1 input
while Screen Link content is sent or shown, it will be
automatically stopped. If you connect HD1 input
while DVI content is sent or shown, it will be
automatically stopped.
SNMP supported version is
SNMPv1 for Traps and SNMPv2c
for reading info.
SNMP is disabled by default to enhance security
SNMP default community
names are easily guessable
Change default SNMP community names or disable
SNMP
SNMP is disabled by default to enhance security
Manual Presence Status is
forced to "Busy" when in a SIP
call when using IP Office as
Presence and SIP Server.
Offline presence status in not
correctly displayed by XT when
using Aura Presence Server 7.1
(pre-release)
Select “Aura 7.1” in XT presence server type
Avaya One-X
Portal for IP Office.
It is not possible to subscribe to
accounts used by One-X Portal
clients.
As a workaround you can temporarily assign the
same account to another XT, subscribe to it from
your XT, and then move it again to the client.
Avaya Aura
Presence Server
Contacts are not notified of
subscription requests. It is not
possible to grant/revoke
subscription request.
XT endpoint must manually
subscribe to other contacts to
view their presence
Remote Control Codes 97, 98,
99 cannot be used any longer to
control the Codec Unit.
Only codes [1...96] can be used to control the codec.
Codes 97, 98 and 99 are reserved to control the
Deluxe Camera since release 8.3.6.
Reprogram your codec and your remote control to
use a different code.
FPS when sending or receiving
Web Collaboration on XT is low
Rx FPS depends on resolution and content of the
remote sharing.
TX FPS depends on resolution and content of local
sharing, but it is further reduced if using an analog
DVI input.
WCS sharing is not active
Check that Calls>Preferences>Dual Video> Web
Collaboration (WCS) is set to Yes
Check that your XT is managed in the meeting (you
should see Local – Your XT Name ) listed in XT UI,
Participants tab if the call is H323 or the
Conferencing Management is 8.3.x.
Check that your XT has a valid DNS configured, as it
must resolve the WCS FQDN.
Check that your XT can connect to the WCS server
(WCS server info are available through XT’s CS
Package)
When WCS Rx is active, there is
no gallery layout
This is by design. Gallery layout preference is
ignored when receiving WCS.
When the received
collaboration resolution is
higher than 1920 width or 1080
height the presentation is
cropped on the monitor.
You can pan/tilt the received presentation using the
arrows when the presentation is displayed in a
major window (full screen or first pap or pop
window in any monitor). Change layout to pan the
near camera in place of the presentation.
Web collaboration cannot be
enabled on systems with CPU
version lower than 2.0
XT cannot send and receive
presentation if the call is audio-
only
MSS cannot be enabled on
systems with CPU version lower
To Next Page
Loading...
