© 2017 Avaya Inc. All rights reserved
Release Notes for Avaya Scopia® XT Series What’s New | 6
What’s New
This section describes some enhancements and fixings available in this software version 9.1.0.37
since previous Avaya XT Series GA version, v9.0.2.44.
Time Settings
In this release, SNTP Servers returned by DHCP (DHCP Option 42, NTP/SNTP RFC 1769), if
available, are preferred to some public Internet Servers for automatic configuration.
[GUI] CONFIGURE>ADVANCED>SYSTEM>DATE&TIME>GENERAL
[WEB] ADMINISTRATOR SETTINGS> SYSTEM>DATE&TIME>GENERAL
Internet Time = Yes
o Use Default NTP Servers: if “Yes”, XT will use the SNTP servers returned by DHCP, if
available; otherwise it will use a list of well-known public servers on the Internet. If
“No”, XT will connect to the manually specified Server 1 or Server 2.
Figure 2: Internet Time, Use Default NTP Servers
In this release, it is also possible to enable geolocation to automatically discover XT time zone.
This allows also the system to apply automatically daylight saving settings, without configuration.
[GUI] CONFIGURE>ADVANCED>SYSTEM>DATE&TIME>TIME ZONE
[WEB] ADMINISTRATOR SETTINGS>SYSTEM>DATE&TIME>TIME ZONE
Enable Geolocation = if “Yes”, the XT will detect automatically the correct time zone and the daylight
time value to be applied. If not, you should specify manually the time zone and the start/stop
dates to apply daylight saving adjustment. Default is “Yes”.
Figure 3: Enable Geolocation for Time Zone Automatic Settings
To Next Page
Loading...
